Loading

Warranty

All Parts Except Wheels & Tires
Have A 7 Month Warranty

Limited Warranty & Installation Procedures For Engines and Transmissions

When making a purchase of a quality recycled auto part from Johnson Auto Recycling. Not only would you save a considerable amount of money over a new part, but you are helping the environment by recycling.

Used Engine Warranty

Prior to the installation of your recycled auto part, you must use OEM specified brand to perform the following pre-installation maintenance. If OEM brand is not used, your warranty is voided. By performing the preinstallation maintenance you will prolong the life of your recycled part and protect its warranty.

Engines come with a 7 month warranty under normal driving conditions. Engines are guaranteed against engine knock and excessive smoking. This limited warranty is void if engine have been disassembled before our inspection or if the center of installed heat tab has been melted or removed. Accessories, such as alternators, starters, carburetors, distributors, fuel pumps and water pumps are not covered under this limited warranty unless otherwise noted on you sale receipt.

Pre-Installation Maintenance:

  • Drain & replace engine oils to manufacturers suggested levels
  • Replace oil filter with OEM oil filter
  • Replace valve cover gaskets
  • Inspect and replace, if needed: timing gears, chains or belts, and gaskets
  • Replace thermostat & gasket
  • Flush cooling system and refill with antifreeze to appropriate level
  • Install new spark plugs
  • Install new belts and hoses

Compare before installation

Used Manual Transmission Warranty

Prior to the installation of your recycled auto part, we suggest that you perform the following preinstallation maintenance. By performing the preinstallation maintenance you will prolong the life of your recyclied part and protect its warranty.

Manual transmissions come with a 7 month warranty under normal driving conditions. For complete warranty information please refer to your sales receipt.

Pre-Installation Maintenance:

  • Replace clutch
  • Replace throw out bearing
  • Replace pilot bushing
  • Replace axle or drive shaft seal
  • Drain gear lubes and fill to manufacturers specifications
  • Inspect & adjust or replace shifter linkage
  • Inspect & replace, if needed, transmission and engine mounts

Compare before installation

Used Automatic Transmission Warranty

Prior to the installation of your recycled auto part, we suggest that you perform the following preinstallation maintenance. By performing the preinstallation maintenance you will prolong the life of your recyclied part and protect its warranty.

Automatic transmissions come with a 7 month warranty under normal driving conditions. For complete warranty information please refer to your sales receipt. All limited warranties are void if transmission has been dismantled prior to our inspection.

Pre-Installation Maintenance:

  • Replace front seals
  • Replace axle seals
  • Install new transmission filter kit
  • Flush & inspect transmission cooling lines
  • Add fluid levels to manufacturers suggested levels
  • Properly align torque converter
  • Adjust throttle position sensor cable
Note: When interchanging between years and models it may be necessary to change Wiring, Linkages and Speedometer Gears/Sensors

Compare before installation